Features

• Bi-Directionally Converts Synchronous RS-530 to V.35
• Supports Data Rates to 2 Mbps, Full or Half Duplex
• Transparent to Protocol
• No AC Power or Batteries Required
• Various DCE/DTE and Gender Combinations Available
• DB-25 and M/34 Connectors with Integral 6 foot (1.8m) Cable
• Circuitry Housed in a Miniature Case
• Made in the USA — This Patton equipment is designed by Patton engineers and built in our Gaithersburg, Maryland facility. Patton's American-made manufacturing process delivers high-quality networking solutions with reliability you can trust.

Overview

The Patton Model 2014 RS-530 to V.35 converter lets a synchronous RS-530 device communicate bi-directionally with a synchronous V.35 device. The Model 2014 requires no AC power or batteries to operate and supports data rates to 2 Mbps. Operating full or half duplex, the Model 2014 passes all necessary clocking and control signals, and is transparent to protocol.

The Patton Model 2014 connects directly to the synchronous RS-530 interface using a male or female DB-25 connector. A male or female M/34 connector at the end of an integral 6 foot (1.8m) cable plugs into the V.35 device. Models with any combination of DTE and DCE wiring are available, thus eliminating the need for special crossover cables.

Specifications

• Interfaces: EIA RS-530/RS-422 to CCITT V.35
• Data Rates: Up to 2.048 Mbps
• Transmission Mode: Full or half duplex
• Protocol: Transparent to protocol
• Clocking: Set by connected devices
• Connectors: DB-25 male or female on RS-530 side, M/34 male or female on V.35 side
• Temperature Range: 32-122°F (0-50°C)
• Altitude: 0-15,000 feet
• Humidity: Up to 95% non-condensing
• Power Supply: None required, uses ultra low power from EIA data and control signals
• Dimensions: 2.66L x 2.10H x 0.73W (6.8 x 5.3 x 1.9 cm
• Weight: 14 oz. (400 grams) including cable

ORDERING INFORMATION