Overview
The Patton Model 1009 and 1015 supports async, point-to-point, RS-232, communicationover two twisted pairs. It is designed to plug into DB-9 and DB-15 interfaces (respectfully), and is compatable with the Patton Model 1000. This short haul is compatible with the Patton Model 1010.
Features
- Support async, point-to-point, RS-232, communication over two twisted pairs
- Designed to plug into DB-9 and DB-15 interfaces (respectfully)
- Compatable with the Patton Model 1000
- Made in the USA — This Patton equipment is designed by Patton engineers and built in our Gaithersburg, Maryland facility. Patton's American-made manufacturing process delivers high-quality networking solutions with reliability you can trust.
Specifications
- Transmission Format: Asynchronous
- Data Rate: 0 to 19,200 bps (no strapping)
- Control Signal: CTS (Pin 8) turns ON immediately after the terminal raises RTS (Pin 7); DSR (Pin 6) and DCD (Pin 1) turn ON immediately after the terminal raises DTR (Pin 4)
- Transmit Line: 4 wire, unconditioned line (2 twisted pair)
- Transmit Mode: Full duplex, 4-wireTransmit Level: 0 dBm
- Line Connection: RJ-11 or RJ-45 jack or 5 screw terminal posts (4 wires and 1 ground) and a strain relief insert; works well with data signals only
- Surge Protection: 600W power dissipation for up to 1 msec (Model 1009S only)
- Power: None required, uses ultra low power from EIA data and control signals
- Dimensions: 2.50" x 1.2" x .75"
ORDERING INFORMATION
Model Name
|
Description
|
1008F
|
MULTIPOINT LINE DRIVER, DB9F
|