The Loop-IP6510 Router/Bridge provides remote bridge connectivity from 4 Ethernet ports to 2 fixed WAN ports and also to 2 optional WAN slots. Whereas the 2 fixed WAN ports are always Ethernet, choices are available for the 2 optional WAN slots. Each of the 2 optional slots can accept one of 4 choices of plug-in cards, which are
(a) a card with dual T1 port
(b) a card with dual E1 port
(c) a card with one 10/100 BaseT fast Ethernet port
(d) a card with one SFP (mini-GBIC) housing for 100M-FX fast Ethernet port
Using the optional dual E1/T1 card, up to 4 E1/T1 lines can be used for WAN connectivity, either separately or in a single bundle.
All Ethernet, WAN, and LAN ports have speed auto-sensing, half/full duplex auto-negotiation, and auto MDI/MDI-X crossover features. All serial (E1/T1) WAN interfaces support PPP, MLPPP, Frame Relay, Cisco-compatible HDLC and HDLC protocols.
The Loop-IP6510 Router/Bridge has a DB9S console port, which allows users to execute in-service diagnostics and fault isolation from a local terminal. It also allows users to manage remotely via Telnet, SSH and SNMP through Ethernet or WAN ports. Multicolor LED indicators and an ACO (Alarm Cut Off) button are provided on the front panel.
- Supports 10/100 BaseT speed auto-sensing, half/full duplex auto-negotiation and auto MDI/MDI-X crossover
- WAN interfaces
- 2 built-in 10/100BaseT WAN interfaces for uplink
- 2 cold plug-in slots supporting any 2 of the following cards:
- E1 card: 2 ports per card, up to 4 ports per system
- T1 card: 2 ports per card, up to 4 ports per system
- Electrical RJ45 Ethernet card: 1 port per card, up to 2 ports per system
- Optical SFP Ethernet card: 1 port per card, up to 2 ports per system
- LAN interfaces
- Four 10/100BaseT LAN interfaces for downlink
- RS232 console port
- Supports SNMP management
- Supports Telnet and SSH remote management
- Supports remote software upgrade
- Supports 802.1a, 802.1w, 802.1q and 802.1ad
- Supports remote bridges
- Supports router
Multiple WANs
MLPPP Bundle
Ethernet as a backup link
RoHS compliant units are identified by the letter G appearing at the end of ordering code.
| Part Number |
Description |
Notes |
|
|
|
